Pordebowl Travel Debowler

To convert the Pordebowl from travel mode to debowler mode, all you need to do is remove the lid, wiggle out the debowling tool, turn it around so the pokey side is sticking up, and then gently press it back into the plastic sheath. One thing that is very important with this debowler is to not force the tool in there. It’s designed to be inserted with gentle pressure, if you really shove it in there it can end up getting a bit stuck and you might need some pliers to pull it out, but with a normal amount of pressure that isn’t going to happen.

When it’s in debowler mode this tool is ideal for emptying out whichever device, stem, or accessory you’re using. The tool has a nice point but it’s not actually sharp, so you don’t need to worry about scratching yourself with it. It tapers down a good length before it meets up with the plastic, so no matter how deep your setup is, this will definitely let you empty it properly.

When you are done with your session and ready to go back into travel mode, simply remove your debowling tool and then drop it into the central post, rather than pressing or forcing it in there. That’s going to give you enough clearance to close the lid properly, and avoid any chance of it getting stuck, so just let gravity do the work.

Aside from acting as a debowler, the sharp end of the debowling tool also makes a perfect stirring tool, you can stir even the smallest load with this because it comes to that nice fine point. Stirring your bowl between sessions is always a good idea as it helps get you the most efficiency and flavor from each load.

When you turn the debowler spike around to the flat end you’ve got a tamping tool you can use to gently press down on your load to get a nice even surface. Tamping your bowl down can help get you the best performance from your device, as the heated air is going to pass through a uniform surface instead of peaks and valleys. So before you start your session and especially in between sessions after you stir it, give your load a gentle tamping for improved results.

Another useful function that it serves is to help remove or replace the CCD into your DynaVap. The size of the flat end will fit perfectly into your DynaVap tip, so this is good for pressing the CCD down to the lowest position. It’s especially useful for using the adjust-a-bowl feature and getting your CCD into those mid range positions, which can be much trickier. If you’re looking to pop out your CCD, just press the pointy end down through the tip and the CCD will pop right out.